Oracle 1z0-1196-25 Value Pack (Frequently Bought Together)

A Landlord Agreement maintains a landlord's service reversion preferences. Which two statements are correct for landlord agreements?

• A. The Landlord Agreement check box on the tenant's service agreement being stopped indicates if a service agreement may be created against the landlord's account.
• B. Reversion terms are always applied to all types of service at a premise.
• C. Reversion terms can be seasonal.
• D. The Landlord Agreement Type defines the reversion terms for a landlord agreement.
• E. Different reversion terms can be defined for each type of service.

An implementation needs to set up a configuration that allows a service point to be used with various metered devices. This configuration should support interval, digital scalar, and analog scalar devices. How could this requirement be met?

• A. Configure one service point type, three device configuration types, and thenconfigure the three valid device configuration types on the service point type.
• B. Configure one service point type, one device type, three device configuration types, and then define these as valid options on the service point type.
• C. Configure one service point type, three measuring component types, and then configure the three valid measuring component types on the service point type.
• D. Configure one service point type, three device types, and then configure the three valid device types on the service point type.

What determines an account's balance?

• A. The sum of all the financial transactions linked directly to the account
• B. The sum of all the financial transactions linked directly to the service agreements related to the account
• C. The logic defined in a plug-in spot on Installation Options
• D. The amount recorded in the "Balance Due" field on an account
• E. The sum of all the balances recorded in the "Balance Due" field on each service agreement related to the account

An implementation is starting an Advanced Meter Infrastructure (AMI) roll-out initiative and they plan to replace their legacy scalar TOU meters with smart meters. They wantto continue to bill for the same TOU periods and they do not want to change the rate being used. Which three actions should an implementation take to support this requirement?

• A. Add a TOU mapping usage calculation rule to the existing usage calculation group.
• B. Add the new usage calculation group to the Customer Rate Schedule extendable lookup for the rate.
• C. Set up the new or existing usage calculation group to be identified dynamically by plug-in logic configured on the usage subscription if not configured already.
• D. Add the TOU mapping usage rule to the Customer Rate Schedule extendable lookup for the rate.
• E. Add a new usage calculation group with a TOU mapping usage calculation rule.
• F. Set up the new usage calculation group to be identified dynamically by plug-in logic configured on the usage subscription's type if not configured already.

An implementation has imported initial measurement data, measurement data in its initial (or raw) form, and it can be viewed through the Measuring Component portal; however, it is not in the "Final" measurement status. What validation has the initial measurement data passed at a minimum?

• A. High/Low Check Validation
• B. Multiplier Check Validation
• C. Sum Check Validation
• D. Critical Validation